– Field portable device
– Sludge level detection, immersion depth up
to 10 m, in primary and secondary clarifier,
thickener, rotten black sludge, sludge level
measuring in small sewage plants
– Adjustable threshold of turbidity detection
– Accumulator battery operated
Range of 100 measurement cycles of 7
minutes each
Automatic switched off after 7 minutes
Charging time of 2 h 30 min as a maximum
– pH/ORP programmable monitor and regulator
– Alphanumeric back lighted LCD display
– Friendly using menu
– Scales: 0 – 14 pH and ± 1000 mV through configuration
– Temperature compensation Automatic or manual
– 2 analogical outputs 0/4-20mA galvanic insulated
– 4 relay outputs (Normally Open contacts)
– 1 input to switch the regulation on Stand-by
– 2 models available:
Panel mounting 72 x 144
Wall mounting IP 65
To connect 9060 cables on any coaxial pH/ORP input and pH electrodes with a connecting head S7 type.
This patented connector is easy to fit on site with our cables (a soldering iron is necessary – technical leaflet provided with the connector).
If there is not a special mention, all our electrodes use a reference system as Ag/AgCl with a porous reference junction in ceramic: theoretical zero is at pH 7 (0 mV).
Theoretical gain is close to 58 mV per pH units (at 20°C).
– CIP disinfection monitoring in Food Industry
– Range: from 0.001 up to 20.0 g /L
– Output signal: 4-20 mA
– With surface-active additives proofed diaphragme
– Pressure limit: 1 bar as a maximum
– Unnecessary zero adjustment
– CIP disinfection monitoring in Food Industry
– Range: from 0.001 up to 20.00 g /L
– Output signal: 0/-2 V
– With surface-active additives proofed diaphragme
– Pressure limit: 1 bar as a maximum
– Unnecessary zero adjustment
– Simple and economic assembly
– pH or ORP in-line measurement
– For gel type electrodes with 13.5 fitting
– Maximal pressure 7 bar/ 20°C
– Maximal temperature 50°C
– Material PVC
– Socket ends diameter 25 mm,
– Options: unions; DN20 PN10 flanges
– Pt 100 Ohm at 0°C
– Compatibility with our electrode holders
– Range: -20°C up to +150°C
This holder is designed for pH / ORP / 0xygen electrode probes by side of a basin or an open channel (see page 130, 135 & 460).
Easy adaptation with adjustable distances and orientation on 360° angle to clear of barrier, post, border…
Equipped with an open cabinet, the monitor is protected and display still readable.
The base and junction devices are made of aluminium.
