CS 0495 Thickness meter
Article no: 0560 0495
The entry of the correct inner diameter is essential for an accurate consumption measurement.
→ Accessories
CS Spot drilling collar
Article no: 0500
If there is no measuring site with 1/2″ ball valve present it can be set up by means of spot drilling collars.
The spot drilling collar is imposed onto the pipe and tightened via thread rods. The enveloping rubber gasket is pressure-tight up to 10 bar. By means of the drilling jig it is possible to drill through the 1/2″ ball valve into the existing pipe.
CS LD 300 Leak detector set
Article no: 0601 0103
If gases escape through leaks ultrasonic noises are generated. By means of the LD 300 leakages can be detected in the ultrasonic range even from distances of several meters. LD 300 transforms the inaudible signals into a frequency which can be identified by means of the provided sound-proof headset. In depressurized systems an ultrasonic tone generator can be used of which the signal travels through smallest openings.
CS LD 300 Leak detector
Article no: 0560 0102
If gases escape through leaks ultrasonic noises are generated. By means of the LD 300 leakages can be detected in the ultrasonic range even from distances of several meters. LD 300 transforms the inaudible signals into a frequency which can be identified by means of the provided sound-proof headset. In depressurized systems an ultrasonic tone generator can be used of which the signal travels through smallest openings.
CS DS 51 Digital panel meter
Article no: 0500 0006
The DS 51 digital panel meter disposes of 2 potential-free alarm contacts (change- over adjusted via the keys. The digital panel meter is supplied with
230 VAC and disposes of an internal mains unit which provides the voltage supply of 24 VDC/100 mA for the sensor.
CS high pressure protection
Recommended for installation from 10 to 50 bar.
By means of a special drilling device a measuring site with 1/2″ ball valve can be easily set up within a few minutes. As an alternative to the welding of the 1/2” fitting also a spot drilling collar can be used.
CS Drilling jig incl. (Ø 13 mm)
Article no: 0530 1108
By means of a special drilling device a measuring site with 1/2″ ball valve can be easily set up within a few minutes.
As an alternative to the welding of the 1/2” fitting also a spot drilling collar can be used.
